Meet the new X4 Fusion (basic ECU replacement).
4 cylinder sequential fuel and spark, upto 8 cylinder paired injectors and wasted spark.
Ignition spark output 5v or 12v selectable.
5 x Analogue inputs.
4 x Digital inputs.
4 x Low current outputs (relay etc).
4 x High Current outputs (idle solenoides,vvt,boost solenoids etc).
VR and Hall triggers supported.
1 x Tach output 5v or 12v selectable.
Integrated Wideband controller.
Integrated WIFI/Bluetooth controller (Air Bear).
Stepper motor Idle control (future 3 x Outputs if not using stepper idle).
Integrated MAP sensor 400kpa.
USB C connection.
Compatible with my Serial Dashes.
Weather resistant USB, Main Connectors, Case (Not recommended for engine bay installs).
Uses Tuner Studio for live tuning.
Fully compatible with Speedyloader firmware updates.
Comes with Main harness connectors, wideband connector and crimp pins to make your wiring harness.

All units are tested on a running engine before sending out.
Please allow approximately 5-7 day lead time for unit to be built and tested.
Every unit is hand assembled at the time of ordering. Takes me around 4 hours to assemble one unit without and accessories.

Currently Compatible with Speeduino firmware, You can read capabilities at http://www.speeduino.com

Please note these controllers are DIY EFI (Aftermarket and possibility not road legal).
The user must have some degree of knowledge of how a engine works and Electronic Fuel Injection systems and Electrical wiring.
As this is a DIY, I take no responsibility on how it is used and damage or harm it could cause.
There is no warranty or responsibility implied in any way.
I will help and support in any way possible and warranty against manufacturing defects.
Physical damage, Vehicle associated or incorrect wiring will not be covered.